Acoustic Image TEN2 Series 4 Combo Amplifiers The world’s smallest, lightest 2x10 combo Channels: The Ten2 is now available in one-channel and two-channel versions. Power: Both Ten2 amplifiers use the same power amplifier, which provides 650w at 4 ohms. Effects: Both Ten2 models now feature the built-in effects. Sound: They also, thanks to the new power amp design, have "dramatically improved fidelity," with lower distortion and even lower noise - and the Series III models were already highly regarded for their low signal-to-noise ratio! Features Balanced, high fidelity sound, with a more in yer face result than the Contra or Coda Cabrio Docking SystemTM allows you to remove the powerful amplifier head for use with other speaker cabinets Two-way sealed (infinite baffle) speaker system 10 inch downward firing woofer 10 inch front firing woofer 2.5 inch coaxial tweeter (mounted in center position in relation to the front firing woofer) with off/two position attenuation switch Phase correcting crossover Exclusive three position (off-medium-high) Room Coupling ControlTM to help tame boomy acoustics Combination Jacks allow the use of a 1/4 inch or XLR input; input impedances are 1 megohm (1/4 inch) or 600 ohms (XLR) based on jack chosen, separately buffered Phantom power (switchable) on XLR inputs Channel Input and master level controls Three Band EQ (each channel): (see control panel layout below) Bass Control: Shelving type, ±15 dB @ 60 Hz Mid Control: ±15 dB @ 650 kHz Treble Control: Shelving type, ±15 dB @ 10 kHz Effects loop with return level control for each channel Separate Digital Effects in/out buttons and level control for each channel Digital Effects 3 Reverbs (Hall, Room, Plate) Delay Ambient Chorus Flange Separate Digital Effects in/out buttons for each channel Phase Invert Switch (per channel) Switchable Low Cut (High Pass) Filter High Pass Filter: -12 dB/octave sweepable from 30 to 700 Hz The High Pass filter lets you reduce the response below a frequency of your choice, to fight the mud on boomy stages and in similar situations Balanced direct out with ground lift and Pre/Post switch Mute switch Headphone output Two Neutrik Speakon Speaker Jacks - no cable for extension speaker is included (short cable for "combo" operation comes with amplifier). Check our cables selection for options 650-Watt "Digital" Power Amplifier, 450w/8 800w/4ohms 1000w/2ohms (internal speaker is 4 ohms) Switchable dual voltage operation (115/230V) Physical Molded polymer results in a stiff but light enclosure Weight: 32 lbs Size: 17 inches high, approx 15 inches by 13 inches (rounded) Molded Carry Handles Detachable AC Input Connector with Built-in Fuse Dual voltage operation (115v/230v, 50/60 Hz) via external switch (comes with USA Cable; to use in other countries, you can source an IEC-C13 AC Cable, also commonly used for computer power supplies.) Comes with fitted slip cover with cord storage pocket and shoulder strap FIVE YEAR WARRANTY
